
TRM01-ET100R
Fractional T1 to 10/100Base-TX
Ethernet Router Card
The TRM01-ET100R Router Card is a single slot card that can be installed in any available slot to provide IP over T1 transmission. The router
engine uses an embedded system which can be configured and controlled from a serial port, Telnet or Web based user interface. It supports
industry standard encapsulations of PPP and HDLC as well as proprietary header for Cisco router's HDLC.
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
Features
Ethernet port IP Address/subnet mask
WAN port IP Address/subnet mask
Router Name / Password
RS-232 Console Port Management
Web/Telnet Management
WAN port IP address/subnet mask
DHCP server/client
NAT Function
Virtual Server Mapping
SNMP MIB-2 supported
Supports VPN pass through
Forwarding IP multicast support
DNS proxy server
SNTP supported
Simple Statistical
Ping and Trace route
Static Routing Setup
Routing Table (manually set up to 32 entries minimum)
Dynamic Routing RIP I & II, Send or Receive on Ethernet or WAN
PPP, HDLC and Cisco HDLC WAN protocol encapsulatoin
Flash Upgrade (via TFTP)
Hardware
Connection
WAN Speed
LAN Speed
Functions
Protocols
Security
LED
Samsung ARM9 integrated communications
166MHz processor, 8MB Flash, and 32MB
pipeline RAM for code, data and buffers
1 x Ethernet LAN port (10/100)
Synchronous Port N56/N64 up to 1544Kbps
Ethernet LAN port 10/100 Mbps
Proxy Routing, IP Routing, Static Routing,
Dynamic Routing, DHCP Client/ DHCP
Server, IP Mapping, Packet Filtering
PPP, NAT, RIP 1/2, TCP/IP
PAP/CHAP, NAT, Filter
Link/ACT : On=link ; Flash=Activity
100 : On=100Base ; Off=10Base
Ordering Information
TRM01-ET100R : Fractional T1 to 10/100Base-Tx Ethernet Router
TTU 01 -E T 100R
Ethernet Ethernet
T R M01-ET 100R
T1 Network
T R M01
5-11
T1 CSU/ DSU Slide-in Card
TRM01-ET100R
www.ctcu.com
Table of Contents
Comentarios a estos manuales