CTC Union FMC-1000S Manual de usuario descargar pdf (Pagina 30)

3.1.10 Logout

Logging out will ensure that the management session with FMC-1000M(S) is terminated. This is especially important if you are using a

public computer to manage the device. Once logged out, a password must be entered to access FMC-1000M(S) again.

Click the “OK” button to completely log out. Click the “Cancel” button to return to configuration of FMC-1000M(S).

3.2 Troubleshooting

3.2.1 Factory Default.

Apply power to FMC-1000M(S) and allow 25-30 seconds to fully boot. Using a pencil or ball-point pen, press the 'DEFAULT' recessed

push-button switch (located on the face plate) and hold for 6 seconds or more then release. DO NOT POWER OFF; Allow the unit to again

fully reboot (about 25 seconds). The factory default TCP/IP settings are:

IP=10.1.1.1

netmask=255.255.255.0

GW=10.1.1.254

The username and password are both reset to 'admin'.

Additionally, any VLAN, 1Q or Q in Q will be disabled. All ports will be enabled, UTP ports set for auto-negotiation and no bandwidth

limiting on any port.

1 2 ... 25 26 27 28 29 30 31 32 33

Sin comentarios

CTC Union FMC-1000S Manual de usuario Pagina 30