CTC Union FMC-1000S Manual de usuario descargar pdf (Pagina 6)

Chapter 1 Introduction

1.1 Welcome

Thank you for choosing FMC-1000M(S) Gigabit Ethernet OAM/IP Web Smart Media Converter. Throughout this document, the two

different models of this family will be referred to as FMC-1000M(S) or in an abbreviated form as just 1000M(S). If you would like to skip right to

the installation of the converter, proceed to Chapter 2.

This manual is used to explain the hardware installation procedures and operation of FMC-1000M(S), and present its capabilities and

specifications. This manual is divided into 3 chapters, the Introduction, Installation, and Provisioning Chapters.

Installers should carefully read the Chapters 1&2, Introduction and Installation. The divisions in that manual are intended for use by

personnel to answer questions in general areas. Planners and potential purchasers may read the Introduction to determine the suitability of the

product to its intended use; Operating Personnel would use Web Based Management Chapters and Appendices to become familiar with the

converter and settings. Network Administrators should read the chapters on Web Based Management and Trouble Shooting to become

familiar with the diagnostic capabilities, network settings and management strategies.

1.2 Product Description

FMC-1000M(S) is an electrical to optical media converter for Gigabit Ethernet. There are two models, one with fixed optical transceiver

(1000M) and one supporting pluggable SFP transceiver (1000MS). These converters sport embedded stand-alone Web based management

over IP networks as well as IEEE802.3ah OAM for remote in-band management. They are also fully compatible when placed in FMC Non-

managed chassis such as the FMC-CH17 or FMC-CH08.

FMC-1000M(S) is an IEEE802.3ah OAM compliant copper to fiber Gigabit Ethernet solution designed to make conversion between

10/100/1000Base-TX and 100/1000Base-FX with SC, FC ,ST connector (FMC-1000M) or SFP LC connector (FMC-1000MS). When deployed

as a stand-alone solution, this media converter incorporates an easy to use Web user interface for operation, administration and maintenance

of both local and remotely connected FMC-1000M(S) converters. By offering 802.3ah OAM compliance, this converter can be linked to any

802.3ah compliant fiber switch and support loop back and dying gasp functions. All functions of this converter and the remotely connected

converter can be configured and monitored via in-band management, including band-width control, duplex, speed, VLAN configuration and

more.

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Sin comentarios

CTC Union FMC-1000S Manual de usuario Pagina 6